Introduction
®
123Scan is a Windows
-based utility that programs the scanner with all parameters including ADF rules. An ADF rule modifies bar
code data before it is sent to the host to ensure compatibility between bar coded data and the host application. Scanners can be
programmed via PC download or by scanning a sheet of bar codes generated by the utility. Scanner programming is saved in a file for
electronic distribution. The 123Scan program includes a help file.
See
Chapter 4, Radio Communications
communication
The scanner must be connected to the cradle for the host parameter setting to take effect. When the scanner
is not connected to a cradle, and a host parameter bar code is scanned, a long low/long high beep sequence
sounds.
Communication with 123Scan
To communicate with the 123Scan program which runs on a host computer running a Windows operating system, use an RS-232 cable
to connect the scanner cradle to the host computer (see
123Scan requirements:
• Host computer with Windows 98, Windows NT, Windows 2000, or Windows XP
• Scanner
• Cradle
• RS-232 cable.
123Scan Parameter
To communicate with the 123Scan program, load 123Scan, included in the documentation CD-ROM, onto the host computer, and scan
the bar code below. Refer to 123Scan instructions for programming the scanner.
Scan the bar code below to enable the 123Scan interface on the scanner.
for information about scanner/cradle pairing and wireless
Connecting an RS-232 Interface on page
123Scan Configuration
123Scan 12-3
7-4).