Scanning In Hand-Held Mode - Motorola Symbol LS4278 User Manual

Scanning in Hand-Held Mode

To program the scanner, see the appropriate host chapter,
parameters included in the chapters mentioned, user preference and miscellaneous scanner option parameters are also available in
this guide.)
To scan:
1. Aim the scanner at the bar code.
2. Press the trigger.
Single-Line Mode
3. Upon successful decode, the scanner beeps and the LED turns green. (For more information about beeper and LED
definitions, see Table 2-1
Scan line lengths vary depending on the scan line width selected (see
scan line width is the default. Medium and short scan line widths are useful for scanning menus or pick-lists.
Chapter , Introduction 4-3
Figure 2-1. Scanning in Hand-Held Mode
and Table 2-2.)
and Chapter 13, Symbologies. (In addition to the
Multi-Line Raster Mode
Scan Line Width on page 5-11). A full
Scanning 2-5