Scanning with Intellistand
When the scanner is placed in Intellistand, the scan pattern selected in hand-held triggered mode continues (see
page
5-10).
When the scanner is configured as a Master or Cradle Host and the Bluetooth connection to the remote device
is lost, the scanner must be removed from Intellistand and re-paired to the remote device. To accomplish this,
pull the trigger which engages the auto-reconnect feature, or scan the pairing bar code for the remote device.
When the scanner is not used for an extended period of time, place it in the cradle for charging. This prolongs
battery life.
To operate the scanner in Intellistand:
1. Ensure the scanner is set up to communicate with the cradle, and the cradle is properly connected to the host and (see the
appropriate host chapter for information on host connections).
2. Insert the scanner in Intellistand by placing the front of the scanner into the stand's "cup."
3. Use the Intellistand's adjustment knobs to adjust the height and angle of the scanner.
4. Present the bar code.
Cup
Scanner Holder
Figure 2-6. Inserting the Scanner in the Intellistand
Angle Adjustment Knob
Height Adjustment Knob
Scanning 2-9
Scan Pattern on