RS-232 Interface 7-17
RTS Line State
This parameter sets the idle state of the Serial Host RTS line. Scan a bar code below to select Low RTS or High RTS line state.
*
Host: Low RTS
Host: High RTS
Beep on <BEL>
Point-to-Point Mode Only
When this parameter is enabled, the scanner issues a beep when a <BEL> character is detected on the RS-232 serial line. <BEL> is
issued to gain a user's attention to an illegal entry or other important event.
This parameter is not supported in Multipoint-to-Point mode.
Beep On <BEL> Character
(Enable)
*
Do Not Beep On <BEL> Character
(Disable)