Turning On/Off The Led Illumination; Setting Up The Remote Control - Canon SX6 User Manual

Turning On/Off the LED Illumination

[LED illumination]
DIGITAL PC
DIGITAL VIDEO COMP./SCART VIDEO/S-VIDEO
You can turn on/off the LED illumination lamp
and the LEDs on the terminals (P24, 25, 26).
System settings
LED illumination
Turns off all LEDs.
Off
Turns on LEDs as necessary.
On
Press the [OK] button to confirm, and then press
the [MENU] button.
This setting does not effect the
POWER indicator or WARNING lamp.
ANALOG PC

Setting up the Remote Control

[Remote control]
DIGITAL PC
DIGITAL VIDEO COMP./SCART VIDEO/S-VIDEO
You can change the channel settings to prevent
the two remote controls from interfering with
each other when you use two projectors at the
same time.
System settings
Other settings
Remote control
Selects the channel on the projector
Ch1
you use.
Ch2
Press the [OK] button to confirm, and then press
the [MENU] button.
Selecting a Channel on the Remote Control
Press the [LIGHT] button for 3 seconds while
holding down the [OK] button on the remote
control.
The above operation toggles the channel
between Ch1 (the button flashes once) and Ch2
(the button flashes twice).
Make sure to set the same channel for
both remote control and projector.
Performing this operation with the
remote control, you cannot control the
projector after pressing the [OK] but-
ton. Make sure to change the channel
for the remote control at the same
time.
Setting Various Function
ANALOG PC
111