Selecting Aspect Ratio Of The Projecting Image (Screen Aspect) - Canon SX6 User Manual

Selecting Aspect Ratio of the Projecting Image
(Screen aspect)
You can select among three aspect ratios of the projecting image according to the aspect
ratio of the projected screen.
You can project an image on the whole screen by setting [Screen aspect].
You can set [Screen aspect] from menu. Refer to the section [Screen aspect] on the
menu for details. (P99)
4:3
Select this when you use a screen with aspect ratio of 4:3.
16:9
Select this when you use a screen with aspect ratio of 16:9.
Select [4:3] from the [Aspect] menu if you want to project a video image with aspect ratio of
4:3 in this mode. (P55)
[Wide] is automatically selected for [Aspect].
[Auto screen color] may not correct the screen color properly. If such is the case, correct it
manually. (P96)
16:9 D. image shift
Perform the following steps to shift the projected image.
1
Press the [KEYSTONE] button on the top control or remote control to open the [D.
image shift adjustment] screen.
2
Press [ ] / [ ] on the top control or remote control to adjust its vertical position.
3
Press the [OK] button.
Select [4:3] from the [Aspect] menu if you want to project a video image with aspect ratio of
4:3 in this mode. (P55)
Keystone adjustment will be disabled. Project the image at right angle to the screen.
[Auto focus], [Auto keystone], and [Auto screen color] are disabled in the [Auto setup] func-
tion.
You cannot register the image for [Projector on], [No signal screen], or [NO SHOW].
[SPOT] will be disabled.
Select this when you use a screen
with aspect ratio of 16:9. You can
vertically shift or fine-tune the posi-
tion of the undistorted image with-
out the keystone adjustment.
57