Setting Up The Power Management Function - Canon SX6 User Manual

You can carry the projector immediately after the use ("Off & Go" function).
You can turn off the projector by disconnecting the power cord without pressing the
[POWER] button (direct power on). (P108)
The LED illumination lamp turns on to indicate the lamp is being cooled when the power
cord is connected.

Setting Up the Power Management Function

You can use the power management function that turns off the lamp if the projector
receives no signal input for a while.
If you enable the power management mode, the projector displays a countdown timer if the
projector is receiving no signal input and is not operated for 30 seconds, and approxi-
mately 5 minutes later the lamp is turned off and the projector goes into the power man-
agement mode.
You can select one of the following power management modes from the menu (P107).
Standby mode
Select this mode if you want to start projection soon.
In the standby mode, the lamp is turned off and cooled down. When the lamp has been
cooled down, the [POWER] indicator starts flashing in red and green to indicate it is
standby. It will start projection if the input signal is inputted or any button on the top control
or remote control is pressed.
Exit mode
Select this mode to turn off the projector automatically.
In the exit mode, the lamp is turned off and cooled down. When the lamp has been cooled
down, the [POWER] indicator stops flashing in red and stays on and the power is turned
off.
The projector becomes inoperative when the lamp is being cooled in a power management
mode.
59