03130031-291D Supr Cam Sensor Error; 03130031-2E23 Cutter Unit Breakdown; 03130031-2F13 A/D Converter External Trigger Output Stopped; 03130031-2F14 Asic Register Cannot Be Written - Canon iPF6100 Service Manual

6.1.3.11 03130031-291D Supr cam sensor error

iPF6000
<Cause>
It failed in the detection of the spur cam sensor.
<Probable fault location>
Spur unit, spur cam sensor, or main controller PCB
<Countermeasure>
1. Visual check
Remove foreign substances from the spur unit if any.
2. Spur cam sensor
Select [SEVECE MODE]>[I/O DISPLAY] to check for normal operation. If the operation is abnormal, replace the feed roller HP sensor.
3. Cable continuity check
If continuity of the cable between the spur cam sensor and the main controller PCB is abnormal, replace the cable.
4. Replace the spur motor.
5. Replace the spur unit.
6. Replace the main controller PCB.

6.1.3.12 03130031-2E23 Cutter unit breakdown

iPF6000
<Cause>
Abnormality occurred in the cutter unit.
<Probable fault location>
Cutter unit, Cutter HP sensor, cutter right position sensor, cutter lift sensor, cutter motor, cutter driver PCB, or main controller PCB
<Countermeasure>
1. Visual check
Remove foreign substances from the cutter unit if any.
2. Cutter home position sensor
Select [SERVICE MODE]>[I/O DISPLAY] to check for normal operation. If the operation is abnormal, replace the cutter home position sensor.
3. Cutter right position sensor
Select [SERVICE MODE]>[I/O DISPLAY] to check for normal operation. If the operation is abnormal, replace the cutter right position sensor.
4. Cutter lift sensor
Select [SERVICE MODE]>[I/O DISPLAY] to check for normal operation. If the operation is abnormal, replace the cutter lift sensor.
5. Cable continuity check
If continuity of the cable between the cutter HP sensor, cutter right position sensor, cutter lift sensor, cutter motor and cutter driver PCB is abnormal, replace the
cable.
6. Replace the cutter motor.
7. Replace the cutter driver PCB.
8. Replace the cutter unit.
9. Cable continuity check
If continuity of the cable between the cutter driver PCB and the main controller PCB is abnormal, replace the cable.
10. Replace the main controller PCB.

6.1.3.13 03130031-2F13 A/D Converter external trigger output stopped

iPF6000
<Cause>
Defective main controller PCB
<Probable fault location>
Main controller PCB
<Countermeasure>
1. main controller PCB

6.1.3.14 03130031-2F14 ASIC Register cannot be written.

iPF6000
<Cause>
A main controller PCB firm ware error occurred.
<Probable fault location>
main controller PCB
<Countermeasure>
1. Turn off the printer, and then turn it off again.
2. Replace the main controller PCB.

6.1.3.15 03130031-2F16 Mist fan error

iPF6000
<Cause>
Mist fan rotation could not be detected during mist fan rotation.
<Probable fault location>
Mist fan or main controller PCB
Chapter 6
0013-3860
0013-3861
0013-3865
0013-3867
0012-6649
6-5