Canon iPF6100 Service Manual page 432

Chapter 8
Display massage
Hardware error.
03130031-4027
Turn off printer,
wait, then
turn on again.
Hardware error.
03130031-2E13
Turn off printer,
wait, then
turn on again.
Hardware error.
03130031-2E32
Turn off printer,
wait, then
turn on again.
Cannot calibrate.
Press OK and try
calibration again.
Calibration
There is a problem
with the
multi-sensor.
Press OK to cancel
calibration.
Hardware error.
03130031-2F3A
Turn off printer,
wait, then
turn on again.
Hardware error.
03130031-2F3B
Turn off printer,
wait, then
turn on again.
Hardware error.
03130031-260E
Turn off printer,
wait, then
turn on again.
Hardware error.
03130031-2618
Turn off printer,
wait, then
turn on again.
Hardware error.
03130031-260F
Turn off printer,
wait, then
turn on again.
Roll feed unit err
Turn off printer and
check roll feed unit
Unknown file.
Check file format.
Turn off printer,
wait a while, then
turn it on again.
Unknown file.
Check file format.
Turn off printer,
wait a while, then
turn it on again.
Roll sensor
cannot detect.
Turn on printer
again.
8-8
Code*
03130031-4027 Lift travel timeout error
03130031-2F13 A/D converter external trigger output
stop detection hardware error 1
03130031-2F32 Multi sensor error
03130031-2F34 Color calibration adjustment failure
error
03130031-2F35 Color calibration disabled
03130031-2F3A Valve motor error
03130031-2F3B CS communication error
0130031-260E Gap detection error
03130031-2618 VH voltage error
03130031-260F Gap reference surface error
03060A00-2E24 Roll feed unit failure
03900001-4049 ROM data for another model has been
transferred.
03900001-4042 MIT data transfer failure
03130031-291A Roll sensor detection failure
Condition detected
Check the carriage unit and surrounding parts.
If both printheads are signaled faulty, take the
following corrective action:
1) Replace the left printhead with a normal one.
2) Because the error indication lasts, turn the printer
off, then back on.
3) Replace the right printhead with a normal one, as
the automatic replacement of the right printhead is
suggested.
If a printhead is not at fault, replace the main controller
board.
Check the environment for interferences from outside
light.
Replace the multi sensor unit.
Check the environment for interferences from outside
light.
Replace the multi sensor unit.
Check the parts counter in service mode.
Replace the multi sensor unit.
Check the ink supply unit.
Remove the ink tanks and then reload them.
Check the main controller PCB.
Check the carriage unit and surrounding parts.
Replace the main controller PCB.
Check the power supply unit.
Replace the reference surface sheet.
Replace the roll feed unit.
Transmit valid ROM data.
Verify the validity of MID data before transferring it.
Check the roll feed unit.
Action