E015-0003-- Cassette 3 (Option Cassette 2) Lift-Up Error; E015-0004-- Cassette 4 (Option Cassette 3) Lift-Up Error; E066-0000-- Environment Sensor Error; E06F-0068-- Eeprom Access Error - Canon imageCLASS LBP325dn Service Manual

E015-0003--
Detection Description
Remedy
E015-0004--
Detection Description
Remedy
E066-0000--
Detection Description
Remedy
E06F-0068--
Detection Description
Remedy
E100-0000--
Detection Description
Remedy
E110-0000--
Detection Description
Remedy
E110-0001--
Detection Description
Remedy
E196-0000--
Detection Description
Remedy
E196-0002--
Detection Description
Remedy
E245-1011--
Detection Description
Remedy
Cassette 3 (Option Cassette 2) lift-up error
Cassette 3 (Option Cassette 2) Lifter Motor error
1. Check the Cassette 3 Lifter Motor (dropout, gear tooth jump, etc.).
2. Check the connector between the Cassette 3 Lifter Motor and the Cassette 3 Driver PCB.
3. Replace the Drive Unit (the Cassette 3 Lifter Motor included)
4. Replace the Cassette 3 Driver PCB.
Cassette 4 (Option Cassette 3) lift-up error
Cassette 4 (Option Cassette 3) Lifter Motor error
1. Check the Cassette 4 Lifter Motor (dropout, gear tooth jump, etc.).
2. Check the connector between the Cassette 4 Lifter Motor and the Cassette 4 Driver PCB.
3. Replace the Drive Unit (the Cassette 4 Lifter Motor included)
4. Replace the Cassette 4 Driver PCB.
Environment Sensor error
Failure of the Environment Sensor was detected.
1. Replace the High Voltage Power Supply PCB (the Environment Sensor included)
2. Replace the DC Controller PCB.
EEPROM access error
Failure of the EEPROM was detected.
1. Turn OFF and then ON the power.
2. Replace the Main Controller PCB.
Laser Scanner error
Failure of the Laser Assembly in the Laser Scanner Unit
1. Check the connector of the Laser Scanner Unit.
2. Replace the Laser Scanner Unit.
3. Replace the DC Controller PCB.
Scanner Motor error
Error in the initial operation of the Scanner Motor
1. Check the connector of the Laser Scanner Unit.
2. Replace the Laser Scanner Unit.
3. Replace the DC Controller PCB.
Scanner Motor error
Error in rotation of the Scanner Motor
1. Check the connector between the Laser Scanner Unit and the DC Controller PCB.
2. Replace the Laser Scanner Unit.
3. Replace the DC Controller PCB.
Firmware error (The host machine or the option cassette)
Engine firmware error
1. Turn OFF and then ON the power.
2. Update firmware.
3. Replace the DC Controller PCB
DC Controller internal error
The memory area in the DC Controller cannot be accessed.
1. Turn OFF and then ON the power.
2. Update firmware.
3. Replace the DC Controller PCB
Host machine FRAM write error
Host machine FRAM write error was detected.
Replace the Main Controller PCB.
198
8. Error/Jam/Alarm