Canon iPF6100 Service Manual page 440

Chapter 8
Display massage
Cannot feed paper.
Press Load/Eject
and reload the
paper.
Paper size not
detected.
Press Load/Eject
and reload the
paper.
Paper loaded
askew.
Press Load/Eject
and reload the
paper.
Cannot adjust
eccentric.
Press Online to
clear the error.
Cassette printing
is selected.
Press Load/Eject
and load sheets.
Roll printing is
selected, but sheets
are loaded.
Press Load/Eject and
remove the sheets.
Roll printing
is selected.
Press Load/Eject
and load a roll.
No Roll Feed Unit.
Turn printer off
and install roll
feed unit.
The roll is empty.
Load/Eject:
Change Paper
Wrong paper feed
slot for this paper
type.
Press Load/Eject
and reload the
paper.
Manual printing
is selected, but a
roll is loaded.
Press Load/Eject and
remove the roll.
Hardware error.
03130031-291D
Turn off printer,
wait, then
turn on again.
Hardware error.
03130031-2E23
Turn off printer,
wait, then
turn on again.
Hardware error.
03130031-2E14
Turn off printer,
wait, then
turn on again.
Hardware error.
03130031-2E16
Turn off printer,
wait, then
turn on again.
8-16
Code*
03010000-2016 Paper jam
03010000-200C Roll media loading size detection failure Reload the roll media.
03016000-2010 Skewed roll media
03010000-2822 Eccentricity correction disabled
03860200-2E02 Data with a cut sheet specification has
been received but no cut sheets are
loaded.
03860200-2E0A Data with a roll media specification has
been received when a cut sheet tray is
loaded.
03060A00-2E00 Data with a roll media specification has
been received but no roll media are
loaded.
03060A00-2E0E Roll media unit not installed
03060A00-2E1B Roll media end
03061000-2E15 Paper type mismatch
03862000-2E0C Data with a cut sheet specification has
been received when roll media are
loaded.
03130031-291D Spur cam sensor detection failure
03130031-2E23 Cutter unit failure
03130031-2F14 Writing to the ASIC register disabled
03130031-2F16 Mist fan error
Condition detected
Reload the paper
Rewind the roll media and reload them.
Check to see if paper has not jammed.
Load cut sheets at the paper tray port.
Replace with roll media.
Load roll media.
Install the roll media unit.
Renew the supply of roll media.
Check the type of paper that can be fed and reload the
paper.
Load cut sheets at the paper tray port.
Check the spur cam sensor.
Check the cutter unit.
Replace the main controller PCB
Check the mist fan.
Action