Table of Contents
Advertisement
3. If you want to play sound through the projector, see page 40 for
instructions on connecting audio cables.
When you've finished making connections, see page 43 for
instructions on turning on the projector and Chapter 2 for
instructions on displaying and adjusting the image.
Connecting an External Monitor
(PowerLite S10+ Only)
If you want to monitor your computer presentation close-up (on a
monitor placed beside the projector) as well as on the screen, you can
connect an external monitor. You can use it to check on your
presentation even if you've pressed the
to a different picture source. Only computer images will appear on the
external monitor, not video images.
First make sure your computer's VGA cable is connected to the
projector's
Computer (Component Video)
connect your monitor to the projector's
button or switched
A/V Mute
port (see page 32). Then
port, as shown:
Monitor Out
Monitor Out
port
note
Some LCD monitors may
not be able to display the
image correctly. If you have
trouble displaying the
image, connect a multiscan
monitor. If you're projecting
computer images, make sure
the computer's refresh rate is
set to 65 Hz or greater.
The projector must be
turned on for the Monitor
Out port to send a signal to
the monitor (though it may
be in standby mode) Make
sure Standby Mode is set to
Communication On
the Extended menu. See
page 75.
Setting Up the Projector
in
39
Advertisement
Table of Contents
