Attach The Wheels - Burley Trailer User Manual

III. Attach the Wheels
First, verify that the tires are infl ated to 30–35 P.S.I. Next, tip the Burley-Solo
frame on its back end (black mesh).
Plastic Wheels
In the hardware bag, you'll fi nd the parts needed to install your plastic
wheels:
(2) 3/8" SAE fl at washer
(2) 3/8" SAE locknut
Slide each wheel over its axle with the refl ectors facing outward. Place a
fl at washer over the axle and secure the wheel with the locknut using a
9/16" wrench. Torque the axle nuts to 12 ft.-lb.
Alloy Wheels
In the plastic bag attached to the alloy wheels, you'll fi nd the parts needed
to install your optional alloy wheels:
(2) 3/8" jam locknuts
NOTE: The optional spoked wheels install with the inset side of the hub
facing outward.
Torque the axle nuts to 12 ft.-lb.
Do not use standard height locknuts on the alloy wheels. Use jam locknuts.
Failure to do so may result in the nut and wheel possibly falling off the
trailer, resulting in an accident and serious injury.
Do not exceed 12 ft.-lb. of torque for axle nuts. Excessive tightening could
damage axle and result in an accident or serious injury
4