Using The Seat Harness - Burley Trailer User Manual

Installing the Safety Flag
Insert the safety fl ag pole into the vertical casing of the left
side panel on the outside of the aluminum side rail. Note
that the base of the fl ag pole slips into a pocket inside the
vertical casing of the side panel.
Knocking Down Your
Burley-Solo
Knocking down your Burley-Solo
is basically the reverse of setting
it up. Familiarize yourself with
setting up the trailer as outlined
in this section above.
To knock down your trailer:
1. Remove the safety fl ag.
2. Remove the tongue by pulling out the hairpin cotter and lock pin
and reversing the process described above. The trailer tongue can
be stored under the child seat.
3. Release the snap hooks behind the child seat. Unscrew the roll
bar knobs and place them in the pocket on the left side panel for
safekeeping. Stow the roll bar and the cover in the bottom of the
Burley-Solo along with the child seat.
4. Release the four side-panel hold-downs. Remove the side-panel
assemblies and lay them between the wheels on top of the main
frame.
5. We recommend leaving the wheels on when knocking down the
Burley-Solo; with the wheels on, it is small enough to transport easily
and reassembly is faster.
VI. Using the Seat Harness
IMPORTANT: The child seat is intended only for a child old enough to wear
a helmet and sit upright alone. Your child must have enough neck strength
to hold his or her head up while trailering.
Crotch strap O-ring must be positioned at child's sternum to work correctly.
An O-ring positioned near child's neck can cause discomfort or serious
injury. Check child periodically to ensure he/she is seated correctly.
10
Pocket to Secure
Base of Flag