Burley Hitch Guide; Opening Your Trailer; Installing The Wheel Guards; Attaching The Wheels - Burley Honey Bee Owner's Instruction And Safety Manual

Burley Hitch Guide:

1. Safety strap
2. Hitch
3. Flex connector
4. Retaining pin
2

Installing the Wheel Guards

1. Insert wheel guard bolts through frame tube.
Match holes in wheel guards to bolts. Tighten
securely with hex key (Figure 4).
2. Repeat for wheel guard on other side of
trailer.
Figure 4
1
3
4

Attaching the Wheels

1. Push in the rubber button on the outside of
the wheel hub (Figure 5).
2. Insert wheel axle into axle receiver, and then
release the button. Pull firmly on wheel to
confirm the axle is fully engaged. (Figure 6)
OWNER'S INSTRUCTION & SAFETY MANUAL

Opening Your Trailer

1. Lift upper frame at rear (Figure 1).
2. Reach through seat for rear frame tube (Figure 2).
3. Squeeze frame tubes together to click securely in
place (Figure 3).
Closing Your Trailer
1. Remove Wheels.
2. Under cover (Figure 3), lift left and right yellow
latches to release frame tubes.
3. Fold flat.
WARNING
Care must be taken when folding and unfolding to
prevent finger entrapment
Figure 5
Figure 1
Figure 3
Figure 6
BURLEY.COM ENG
Figure 2
3