SOLTEK SL-65DVB User Manual page 57

Primary
Master / Slave UDMA
Secondary
Master / Slave UDMA
Init Display First This option allows you to decide to activate PCI Slot
IDE HDD Block Mode Block mode is also called block transfer, multiple
Onboard FDC
Controller
Onboard Serial
Port 1 / Port 2
UART 2 Mode This item allows you to select which mode for the
IR Function Duplex This item allows you to select the IR half / full duplex
Ultra DMA/66 implementation is possible only if your
IDE hard drive supports it and the operating environ-
ment includes a DMA drive and your system software
both support Ultra DMA/66, select Auto to enable
BIOS support.
The choice: Auto, Disabled.
or AGP first.
The choice: PCI Slot, AGP.
commands, or multiple sector read/write. If your IDE
hard drive supports block mode (most new drives do),
select Enabled for automatic detection of the optimal
number of block read/write per sector the drive can
support.
The choice: Enabled, Disabled.
Select Enabled if your system has a floppy drive con-
troller (FDC) installed on the system board and you
want to use it. If you install add-in FDC or the system
has no floppy drive, select Disabled in this field.
The choice: Enabled, Disabled.
Select an address and corresponding interrupt for the
first and second serial ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/
IRQ3, Disabled, Auto.
Onboard Serial Port 2.
The choice: Standard, HPSIR, ASKIR
function.
The choice: Half, Full.
65DVB/65DV2
57