Sony DCR-PC115E Operating Instructions Manual page 95

Dubbing only desired scenes
– Digital program editing (on tapes)
Step 1: Connecting the VCR
You can connect both an A/V connecting cable
and an i.LINK cable (DV connecting cable).
When you use the A/V connecting cable, connect
the devices as illustrated on page 91. When you
use an i.LINK cable (DV connecting cable),
connect the devices as illustrated on page 93.
If you connect using an i.LINK cable (DV
connecting cable)
With digital-to-digital connection, video and
audio signals are transmitted in digital form for
high-quality editing.
Step 2: Setting the VCR to
operate with the A/V
connecting cable
To edit using the VCR, send the control signal by
infrared rays to the remote sensor on the VCR.
When you connect using an A/V connecting
cable, follow the procedure below, (1) to (4), to
send the control signal correctly.
(1) Set the IR SETUP code
1 Set the POWER switch to VCR on your
camcorder.
2 Turn the power of the connected VCR on,
then set the input selector to LINE.
When you connect a video camera recorder,
set its power switch to VCR/VTR.
3 Press MENU, then select and decide upon
VIDEO EDIT in
(p. 132).
4 Select and decide upon TAPE with the control
button.
5 Select and decide upon EDIT SET with the
control button.
6 Select and decide upon CONTROL with the
control button.
7 Select and decide upon IR with the control
button.
8 Select and decide upon IR SETUP, then select
and decide upon IR SETUP code of your VCR
with the control button.
Check the code in "About the IR SETUP
code." (p. 97)
with the control button
(1) (4)
(1)
1
2
3
4
5
6
7
8
95