Dv Connecting Cable - Sony DCR-PC115E Operating Instructions Manual

Dubbing only desired scenes
– Digital program editing (on tapes)
(4) Confirming the VCR operation
1 Insert a recordable tape into the VCR, then set
to recording pause.
2 Select and decide upon IR TEST with the
control button.
3 Select and decide upon EXECUTE with the
control button.
If the VCR starts recording, the setting is
correct.
When recording is finished, the indicator
changes to COMPLETE.
When the VCR does not operate correctly
•After checking the code in "About the IR
SETUP code", set the IR SETUP or the
PAUSEMODE again.
•Place your camcorder at least 30 cm (12 in.)
away from the VCR.
•Refer to the operating instructions of your VCR.
Step 2: Setting the VCR to operate
with the i.LINK cable

(DV connecting cable)

When you connect using i.LINK cable (DV
connecting cable) (optional), follow the
procedure below.
(1) Set the POWER switch to VCR on your
camcorder.
(2) Turn the power of the connected VCR on,
then set the input selector to DV input. When
you connect a digital video camera recorder,
set its power switch to VCR/VTR.
100
(4)
1
2
3
2
V I D EO E D I T
E D I T / S E T
CON T RO L
A D J T E S T
" CU T - I N "
" CU T -OU T " E NGAGE
I R S E T U P R E C
P A U S EMOD E
I R T E S T R E T U R N
R E T U R N E X E C U T E
[ ME N U ] : E N D
3
V I D EO E D I T
E D I T / S E T
CON T RO L
A D J T E S T
" CU T - I N "
" CU T -OU T "
I R S E T U P
P A U S EMOD E
I R T E S T COMP L E T E
R E T U R N
[ ME N U ] : E N D
•
•
•
(1)
(2)
0 : 0 8 : 5 5 : 0 6
C P A U S E
0 : 0 8 : 5 5 : 0 6