MIC440 Explosion-protected Camera
8
Mount the Camera
To mount a MIC Series camera, follow these steps:
Warning!
!
Ensure not to damage the paint work on the housing of the camera or the mount.
1. Carefully lift the camera to the mounting location.
2. Connect the female cable connector end (12-pin) of the shielded composite cable to the
male plug in the base of the camera. Screw the cable connector sleeve onto the plug until it is
secured firmly (approximately four (4) turns from the start of thread engagement).
Bosch Security Systems, Inc.
Operation Manual
Mount the Camera | en
27
2013.11 | 8.1 |