Table of Contents
Advertisement
6
en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts
1.3
Mount Power Supply Box
Before mounting the Power Supply Box decide if you should wire the box through the holes in
the bottom or back of the box. If wiring the box through the back, move the two (2) seal plugs
to the bottom through the holes before mounting.
NOTICE! Use 3/4-inch (20-mm) NPS fittings for the holes on the bottom and back of the box.
i
Use 1/2-inch (15-mm) NPS fittings for the side holes.
Fig. 1.2 Power Supply Wall, Mast (Pole), and Corner Mounts
1.
Use the wall mount template supplied in the packaging box to locate the four mounting
holes for the Power Supply Box.
2.
Drill four (4) holes for the mounting anchors. If installing outdoor, apply a weatherproof
sealant around each hole at the mounting surface.
WARNING! A stud diameter of 6.4 mm (1/4 inch) to 8 mm (5/16 inch) able to withstand a
!
120 kg (265 lb) pull-out force is recommended. The mounting material must be able to
withstand this pull out force. For example, 19-mm (3/4-inch) minimum for plywood.
3.
Place the Power Supply Box into its Trim Skirt.
4.
Secure the Power Supply Box to the mounting surface.
–
–
–
5.
Secure the Power Supply Box to the Corner Plate or Mast Plate using the four (4)
3/8 x 1-3/4-inch bolts and split lock washers (supplied).
6.
Attach 3/4-inch (20-mm) NPS watertight pipe fittings (not supplied) to the bottom or
back holes of the Power Supply Box through which you will run the power, video, and
control data wires.
F01U010921 | 1.0 | 2006.10
For a Wall installation: Use four (4) corrosion-resistant, stainless steel studs (not
supplied). Then proceed to Step 5 below.
For a Mast or a pole installation: You must use a banding tool (sold separately) for a
mast or pole installation. Follow the instructions provided with the banding tool to
securely mount the Mast Plate to the pole. Contact your Bosch Sales Representative
to order Banding Tool P/N TC9311PM3T.
For a Corner installation: Secure the Corner Plate to the wall corner using four (4)
studs (not included). Then proceed to Step 5 below.
Installation Manual
AutoDome Modular Camera System
Bosch Security Systems, Inc.
Advertisement
Table of Contents
