Fit The Optional Sunshield (Mic440) - Bosch MIC440 Operation Manual

40 en | Fit the Optional Sunshield (MIC440)
12

Fit the Optional Sunshield (MIC440)

The MIC440 Sunshield is designed to provide additional protection against direct solar
radiation by reflecting solar exposure and creating an insulating gap between the environment
and the surface of the camera. It is a two (2) part moulding and comes supplied with four (4)
stainless steel set screws.
Caution!
! DO NOT REMOVE the lid from the camera, and do not back drive the pan or tilt axis manually.
Doing so will void the warranty. Back driving may also strip teeth off the internal gears.
To fit the sunshield, follow these steps:
1.
2.
3.
4.
5.
6.
Figure 12.1: Sunshield and Screws being placed
2013.11 | 8.1 |
Turn on the power to the camera so that you can rotate the camera head up to fit the
bottom half of the sunshield (steps 2 through 4).
Rotate the camera under power--do not rotate by hand--until the bottom of the camera
head is facing up.
Align the 4 posts/alignment tabs and the two screw holes of one piece of the sunshield
with the corresponding posts and holes on the camera head. Push the sunshield until it
fits snugly onto the camera head.
Place two of the socket head screws into the screw holes. Fasten the screws with a Torx
wrench.
Rotate the camera under power--do not rotate by hand--until the top of the camera head
is facing up.
Repeat steps three and four for the second half of the sunshield. When fitted properly,
both halves of the sunshield should align and meet at the back of the camera head.
Operation Manual
MIC440 Explosion-protected Camera
Bosch Security Systems, Inc.