Kubota SM-E3B Series Workshop Manual page 53

SM-E3B SERIES WSM
NOTE
• The following special tools are not provided, so make them referring to the figure.
Injection Pump Pressure Tester
Application: Use to check fuel tightness of injection pumps.
Pressure gauge full scale : More than 29.4 MPa
A
2
(300 kgf/cm , 4270 psi)
B PF 1/2
C Copper gasket
D Flange (Mateiral Steel)
E Hex. nut 27 mm (1.1 in.) across the plat
F Adhesive application
G Fillet welding on the enter circumference
H Retaining nut
I 17 mm dia. (0.67 in. dia.)
J 8.0 mm dia. (0.31 in. dia.)
K 1.0 mm (0.039 in.)
L 17 mm dia. (0.67 in. dia.)
M 6.10 to 6.20 mm dia. (0.241 to 0.244 in. dia.)
N 8.0 mm (0.31 in.)
O 4.0 mm (0.16 in.)
P 11.97 to 11.99 mm dia. (0.4713 to 0.4720 in. dia.)
Q PF 1/2
R 23 mm (0.91 in.)
S 17 mm (0.67 in.)
T 4.0 mm (0.16 in.)
U 12.00 to 12.02 mm dia. (0.4725 to 0.4732 in. dia.)
V 100 mm (3.94 in.)
W M12 × P1.5
X 5.0 mm (0.20 in.)
Valve Guide Replacing Tool
Application: Use to press out and press fit the valve guide.
A 220 mm (8.66 in.)
B 80 mm (3.1 in.)
C 40 mm (1.6 in.)
D 20 mm dia. (0.79 in. dia.)
E 9.960 to 9.980 mm dia. (0.3922 to 0.3929 in. dia.)
F 5.50 to 5.70 mm dia. (0.217 to 0.224 in. dia.)
G 25 mm dia. (0.98 in. dia.)
H 6.00 to 6.10 mm dia. (0.237 to 0.240 in. dia.)
I 5.0 mm (0.20 in.)
J 18 mm dia. (0.71 in. dia.)
K 10.6 to 10.7 mm dia. (0.418 to 0.421 in. dia.)
L 6.90 to 7.10 mm (0.272 to 0.279 in.)
C1 Chamfer 1.0 mm (0.039 in.)
C2 Chamfer 2.0 mm (0.079 in.)
C0.3 Chamfer 0.3 mm (0.01 in.)
G-34
G GENERAL
W10252400
W10250170
KiSC issued 03, 2011 A