Kubota SM-E3B Series Workshop Manual page 79

SM-E3B SERIES WSM
Z482/D722-E3B (3600 min
Injection timing
(Serial No. : below 7ZZ999)
Injection timing
(Serial No. : above 8A0001)
-1
D782-E3B (3200 min (rpm) spec.)
Injection timing
(Serial No. : below 7ZZ999)
Injection timing
(Serial No. : above 8A0001)
Z602/D902-E3B (3600 min
Injection timing
(Serial No. : below 7ZZ999)
Injection timing
(Serial No. : above 8A0001)
Injection Timing (Continued)
NOTE
• The liquid gasket is not required for assembling.
• Shims are available in thickness of 0.20 mm (0.0079 in.), 0.25
mm (0.0098 in.), 0.30 mm (0.012 in.), 0.35 mm (0.014 in.) and
0.175 mm (0.00689 in.).
adjustments.
• Addition or reduction of shim (0.025 mm, 0.00098 in.) delays
or advances the injection timing by approx. 0.0044 rad
(0.25 °).
• In disassembling and replacing the injection pump, be sure
to use the same number of new shims with the same
thickness.
• The 0.175 mm (0.00689 in.) thick shim is coated only on the
lower face. Therefore, do not use the 0.175 mm (0.00689 in.)
thick shim as the top shim of the combination (injection
pump side), because this can cause oil leakage.
• Refer to figure of the shim to check the thickness of the
shims.
• The injection timing might be changed by the application.
S-18
DIESEL ENGINE
-1
(rpm) spec.)
0.3491 to 0.3839 rad
Factory spec. (20.00 to 22.00 °) before
T.D.C.
0.3535 to 0.3796 rad
Factory spec. (20.25 to 21.75 °) before
T.D.C.
0.2793 to 0.3141 rad
Factory spec. (16.00 to 18.00 °) before
T.D.C.
0.2837 to 0.3097 rad
Factory spec. (16.25 to 17.75 °) before
T.D.C.
-1
(rpm) spec.)
0.3317 to 0.3665 rad
Factory spec. (19.00 to 21.00 °) before
T.D.C.
0.3360 to 0.3621 rad
Factory spec. (19.25 to 20.75 °) before
T.D.C.
Combine these shims for
W1018724
W1018986
KiSC issued 03, 2011 A