Kubota SM-E3B Series Workshop Manual page 108

SM-E3B SERIES WSM
Main Bearing Case Assembly
(Z482-E3B, D722-E3B, D782-E3B)
1. Remove the two main bearing case screws 1 (4), and remove the
main bearing case assembly 1 (1), being careful with crankshaft
bearing 3 (5).
2. Remove the main bearing case assembly 2 (2) and the main
bearing case assembly (3) as above. Keep in mind, however,
that the thrust bearing (7) is installed in the main bearing case
assembly (3).
(When reassembling)
• Clean the oil passage in the main bearing cases.
• Apply clean engine oil to the bearings.
• Install the main bearing case assemblies in original positions.
Since diameters of main bearing cases vary, install them in order
of marking (b) (1 for Z482-E3B and 1, 2 for D722-E3B, D782-
E3B) from the gear case side. (Refer to the figure.).
• Match the alignment numbers (a) on the main bearing case
assembly 1 (1).
• Do the same for the main bearing case assembly 2 (2) and the
main bearing case assembly (3) too.
• When installing the main bearing case 1 and 2, face the mark
"FLYWHEEL" to the flywheel.
• Install the thrust bearing (7) with its oil groove facing outward.
• Confirm that the main bearing case moves smoothly after
tightening the main bearing case screw 1 to the specified torque.
Tightening torque Main bearing case screw 1
(1) Main Bearing Case Assembly 1
(2) Main Bearing Case Assembly 2
(3) Main Bearing Case Assembly
(4) Main Bearing Case Screw 1
(5) Crankshaft Bearing 3
(6) Crankshaft Bearing 2
(7) Thrust Bearing
S-47
DIESEL ENGINE
13 to 15 N·m
1.3 to 1.6 kgf·m
9.4 to 11 lbf·ft
(a) Alignment Number
(b) Marking (1 or 2)
W1031597
KiSC issued 03, 2011 A