Kubota SM-E3B Series Workshop Manual page 29

SM-E3B SERIES WSM
Replacing Oil Filter Cartridge
CAUTION
• Be sure to stop the engine before changing filter cartridge.
1. Remove the oil filter cartridge (1) with the filter wrench.
2. Apply a slight coat of oil onto the new cartridge gasket.
3. To install the new cartridge, screw it in by hand. Over tightening
may cause deformation of rubber gasket.
4. After the new cartridge has been replaced, the engine oil
normally decrease a little. Thus see that the engine oil does not
leak through the seal and be sure to read the oil level on the
dipstick. Then, replenish the engine oil up to the specified level.
IMPORTANT
• To prevent serious damage to the engine, replacement
element must be highly efficient.
genuine filter or its equivalent.
NOTE
• The oil pan of 101 mm (3.98 in.) depth is optional for Z482-
E3B and D722-E3B. This service interval is every 150 hours.
(1) Engine Oil Filter Cartridge
G-10
G GENERAL
Use only a KUBOTA
[a] Standard Type
[b] One-side Maintenance Type
W1017137
KiSC issued 03, 2011 A