Kubota SM-E3B Series Workshop Manual page 104

SM-E3B SERIES WSM
Piston
1. Turn the flywheel and bring the piston to top dead center.
2. Draw out the piston upward by lightly tapping it from the bottom
of the crankcase with the grip of a hammer.
3. Draw out the other pistons after the same method as above.
(When reassembling)
• Before inserting the piston into the cylinder, apply enough engine
oil to the cylinder.
• When inserting the piston into the cylinder, face the mark on the
connecting rod to the injection pump.
IMPORTANT
• Do not change the combination of cylinder and piston. Make
sure of the position of each piston by marking. For example,
mark "1" on the No. 1 piston.
• When installing the piston into the cylinder, place the gaps
of all of the piston rings as shown in the figure.
• Carefully insert the piston using a piston ring compressor
(1). Otherwise, their chrome-plated section may be
scratched, causing trouble inside the cylinder.
Models
Z482-E3B, D722-E3B
D782-E3B
Z602-E3B, D902-E3B (3200 min
Z602-E3B, D902-E3B (3600 min
(1) Piston Ring Compressor
(A) Top Ring Gap
(B) Second Ring Gap
(C) Oil Ring Gap
(D) Piston Pin Hole
S-43
DIESEL ENGINE
Mark
-1
(rpm) spec.) 1C
-1
(rpm) spec.) 2D
(a) 0.79 rad (45 °)
(b) 0.79 rad (45 °)
(c) 1.6 rad (90 °)
(d) Mark
KiSC issued 03, 2011 A
3
B
W10277450