Servicing; Cylinder Head And Valves - Kubota SM-E3B Series Workshop Manual

SM-E3B SERIES WSM

[3] SERVICING

(1) Cylinder Head and Valves

Top Clearance
1. Remove the cylinder head.
2. With the piston at TDC, use grease to affix three or four
plastigauges of a diameter 1.5 mm (0.059 in.) x 5.0 to 7.0 mm
(0.20 to 0.27 in.) long to the crown of the piston; keep the gauges
away from the intake valve and combustion chamber fittings.
3. Take the piston to an intermediate position, install the cylinder
head and tighten the head bolts to the specified torque.
4. Turn the crankshaft so the piston goes through TDC.
5. Remove the cylinder head and measure the thickness of the
plastigauges.
6. If they are out of spec, check the oil clearance of the crank pin
journal and piston pins.
Top clearance Factory spec.
Tightening torque Cylinder head screw
(1) Plastigauge
Cylinder Head Surface Flatness
1. Clean the cylinder head surface.
2. Place a straightedge on the cylinder head's four sides and two
diagonal as shown in the figure.
3. Measure the clearance with a thickness gauge.
4. If the measurement exceeds the allowable limit, correct it with a
surface grinder.
IMPORTANT
• Do not place the straightedge on the combustion chamber.
• Be sure to check the valve recessing after correcting.
Cylinder head surface
Allowable limit
flatness
S-53
DIESEL ENGINE
0.50 to 0.70 mm
0.020 to 0.027 in.
38 to 42 N·m
3.8 to 4.3 kgf·m
28 to 31 lbf·ft
(2) Scale
W1020190
0.05 mm
0.002 in.
W1027737
KiSC issued 03, 2011 A