Lower Spray Arm Support; Perforated Stainless Steel Rh Side Wash Filter - GE Monogram ZBD6400 Series Technical Service Manual

6000 & 7000 Series DISHWASHERS

5.2.24 Lower Spray Arm Support

The Lower Spray Arm Support positions and retains the
Lower Spray Arm via an annular boss which engages two
clips on the Lower Spray Arm Venturi.
Note: The top end of the Lower Spray Arm Support, has
markings designating the "max" and "min" operating water
level. If the Lower Spray Arm Venturi clips cover the markings
rotate the Lower Spray Arm by hand to observe and identify
both markings. Refer to these markings when adjusting the
fill time (section 4.3). The Lower Spray Arm Support is
screwed into the Sump by means of a RH buttress thread
formed on the lower end of the Lower Spray Arm Support.
5.2.24.1 To remove the Lower Spray Arm Support, first
remove the Lower Spray Arm and Recuperative By-pass
Filter.
5.2.24.2 Unscrew the Lower Spray Arm Support and lift clear.
Unscrew Lower Spray Arm Support to remove
Note: The RH side perforated stainless steel Wash Filter is
retained in position and clamped down by the action of
screwing the Lower Spray Arm Support into the threaded
socket within the sump.
5.2.24.3 Reassemble the dishwasher in reverse order.
5.2.25 Perforated Stainless Steel RH side Wash
Filter
5.2.25.1 To remove the RH side perforated stainless steel
Wash Filter first remove the Lower Spray Arm and the
recuperative by-pass filter, and then remove the Lower
Spray Arm Support (Section 5.2.21).
5.2.25.2 The RH side perforated stainless steel Wash Filter
can now be lifted out.
NOTE: A breather port positioned at the rear of the perforated
wash filter requires to be clear of obstructions. A blockage
can cause the pump to cavitate and cause a reduction in the
wash performance.
5.2.25.3 To reinstall, replace the RH side perforated stainless
steel Wash Filter in position, insert the threaded boss end of
the Lower Spray Arm Support through the 1 3/8" diameter
recessed hole in the perforated face of the filter and tighten.
Reassemble the dishwasher in reverse order.
Breather port
RHS Wash Filter
Note: The flange on the Lower Spray Arm Support exerts
pressure onto the filter face and retains/locates the RH side
perforated stainless steel Wash Filter in position.
PAGE 46