GE Monogram ZBD6400 Series Technical Service Manual page 62

6000 & 7000 Series DISHWASHERS
5.2.42 Door Handle Cover Plate - 6400, 6500, 6700,
6900 & 6905 Models
CAUTION. Switch off electrical power supply.
5.2.42.1 Remove the Door Handle.
5.2.42.2 Grasp the flange of the Door Handle Cover Plate
which protrudes below the bottom edge of the Carrier Panel
and spring both retaining spigots from the Carrier Panel.
Door handle Cover Plate
5.2.42.3 Remove Door Handle Cover Plate spring. Refer to
the picture below.
5.2.42.4 Reassemble the dishwasher in reverse order.
5.2.42.5 Operate and test dishwasher before leaving.
5.2.43 Door Lock Microswitch - 6400, 6500, 6700,
6900, 6905, 6600 & 6605 Models
5.2.43.1 Remove both 1/4" terminals and wires from tab
terminals of the Microswitch and snip the retaining cable tie
from the body of the Microswitch.
5.2.43.2 Slide the tip of a small screw driver between the
Microswitch and the surface of the Carrier Panel. With a pair
of point-nose pliers, insert a point nose tip of the pliers into
the adjacent mounting hole of the Carrier Panel. Position the
other point of the pliers on to the Microswitch top retainer clip
and carefully release the retainer clip. At the same time, lift
the Microswitch, with the small screwdriver, which will assist
removal of the Door Lock Microswitch.
5.2.43.3 Repeat procedure with lower retainer clip, although
clip will require to be unlatched without the aid of a mounting
hole to gain purchase. Carefully lift Microswitch from the two
mounting posts and lift clear. Reassemble the dishwasher in
reverse order. To reinstall the Microswitch a replacement
cable tie is required.
5.2.43.4 Operate and test dishwasher before leaving.
Spring
CAUTION. Switch off electrical power supply.
PAGE 60