GE Monogram ZBD6400 Series Technical Service Manual page 36

6000 & 7000 Series DISHWASHERS
5.2.3.2 Remove the 4 Phillips head stainless steel screws
fitted to each side of the door to enable the Door Panel to be
withdrawn from the stainless steel door liner. While removing
the 8 stainless steel screws, ensure the Door Panel is
supported. It is suggested to leave one central screw loose
and in place for support while removing the three stainless
steel screws on each side of the door.
5.2.4 Door Panel for 7000, 7005, 7100 & 7105 Models
CAUTION. Switch off electrical power supply
Note. The door panel must be removed to improve
access to the control panel.
5.2.4.1 Open the door to the horizontal position. Remove 3
Phillips head long (21/2") screws fixing the timber or stain-
less steel decorative panel to the door panel.
Screws fixing decorative panel
5.2.4.2 Close the door. Lift the decorative panel upwards to
disengage the toggles holding it to the door panel. Pull the
decorative panel forward and lift clear from the dishwasher.
Lift panel upwards to disengage
5.2.4.3 Open the door to the horizontal position. Remove the
remaining 13 Phillips head screws from the sides and top
from the stainless door liner.
5.2.4.4 Supporting the door panel with your legs to hold it in
position, grasp the metal carrier panel and remove the ribbon
cable connector from the power control board as shown
below.
Remove the 1/4" quick connect earth (ground) wire from the
earth (ground) tab on the door.
Door Panel Metal Carrier Panel
Ribbon cable and connector
5.2.4.5 Lift the door panel clear. The power control board will
remain on the carrier panel, giving access to both internal
and external components.
NOTE: The wiring harness will restrict movement of the door
panel.
5.2.4.6 Reassemble the dishwasher in reverse order.
5.2.4.7 Operate and test dishwasher before leaving.
PAGE 34