Fill Funnel; Lower Spray Arm, Fine Filter, And Inlet Cover; Main Conduit; Upper Spray Arm - GE Monogram ZBD6800K Technical Service Manual

Lower Spray Arm, Fine Filter, and Inlet
Cover
Check the holes in the spray arm for bits of china,
seeds, and other foreign matter. Also check the
spray arm for rotation. If soil is present, clean fi ne
fi lter screen.
The lower spray arm can be removed by gently
lifting and rotating it coun ter clock wise.
The nut hub can be removed by rotating it
counterclockwise.
Caution: Use care to avoid breaking the clip on
the hub when removing the main conduit from
hub.
Note: When installing the fi ne fi lter, make sure
the drain port of the fi lter is engaged with the
drain for the fi ne fi lter.
Fine Filter
Drain Port
Drain For
Fine Filter
Coarse Filter
Float Dome

Upper Spray Arm

Check the holes in spray wash arm for bits of
china, seeds, and other foreign matter. Also,
check the spray arm for rotation.
To remove the upper spray wash arm, remove the
upper basket (See
Middle Spray Wash Arm),
remove the screw and upper spray wash arm.
Lower
Spray Arm

Main Conduit

Mounting Screw
Main Conduit
Nut Hub
Fine Filter
Assembly
Cover Inlet
Main Conduit
Hub
Tab
then
Main Conduit
The main conduit supplies water to the middle
and upper spray wash arms.
Removal and Replacement
1. Pull the upper rack out.
2. Push the tab on the outer slide cap in and
remove the slide cap.
3. Remove the upper basket.
4. Release the bottom conduit tab.
5. Release the 2 center conduit tabs, then
remove the main conduit.

Fill Funnel

The top section of the fi ll funnel separates from
the main body. The fi ll funnel body is held in place
by a nut (located on the inside of the dishwasher).
Rotate the nut counterclockwise to remove the
main body. There is an O-ring seal be tween the
fi ll funnel and dish wash er tub. Make certain the
O-ring is fully seated when reinstalling.
Nut
– 11 –
O-ring