6.3 Remedying Typical Troubles
fi-6140 / fi-6240 Image Scanner Operator's Guide
6.3 Remedying Typical Troubles
Symptom: The scanning does not start.
Back
Did you unlock the transport lock of the
Flatbed? (fi-6240 only)
Are the document loaded correctly on the ADF
paper chute?
Is the ADF closed completely?
Is the interface cable connected correctly?
Is the connector of interface cable broken?
(When using scanner on SCSI interface)
Is the SCSI ID set correctly?
file:////10.232.227.50/Manual/fi-6140_6240C-Lynx3/OG/R02/02_081030/contents/EN/06/c06_03/03.htm (1/2) [2008/10/30 12:41:01]
YES
YES
YES
YES
NO
YES
Turn OFF the scanner and unlock the transport
lock.
(Refer to "2.1 Installing the Scanner in "fi-
NO
6140/fi-6240 Getting Started.")
Load the document correctly on ADF paper
chute.
NO
Remove the document in the ADF paper chute,
open the ADF, and then close it completely.
NO
Connect the interface cable correctly.
(Refer to "2.2 Connecting the Scanner to Your
NO
PC" in "fi-6140/fi-6240 Getting Started.")
Use a new interface cable and correctly
connect it.
YES
Turn OFF the scanner and set the SCSI ID
correctly, then turn ON the scanner again.
(Refer to "2.2 Connecting the Scanner to Your
NO
PC" in "fi-6140/fi-6240 Getting Started.")
TROUBLESHOOTING
CONTENTS MAP
TOP