Fujitsu fi-6140 Operator's Manual page 123

3.18 Not Detecting Multifeed for Fixed Format
How to Configure Settings with Software Operation Panel
1. Open the Software Operation Panel.
For details, see Section
2. Select the [Device Setting 2] tab from the list on the left of the panel, and then select [Intelligent
Multifeed Function].
3. Using this tab, do the following:
Intelligent Multifeed Function
●
Select one of three modes described above.
Clear overlap pattern
●
If this checkbox is marked, the remembered length and location of glued paper (overlap pattern) are deleted
from memory. Note that the overlap pattern is automatically cleared once you change the bypass mode while
[Do not remember] is selected under [Remember multifeed pattern at power-off]. If [Remember] is selected in
this situation, the pattern will not be cleared. (Up to eight patterns can be remembered at power-off.)
Before Using This Function
Configure the following settings before using this function:
file:////10.232.227.50/Manual/fi-6140_6240C-Lynx3/OG/R02/02_081030/contents/EN/03/c03_18_01.htm (3/6) [2008/10/30 12:42:24]
"8.1 Scan Settings."