Mendota DXV-60 Installation & Operating Instructions Manual page 22

Information specific to the installation of Millenia Flat Grills, Victoria Filigrees and Tus-
cany Filigrees
The Millenia Flat Grills, Victoria Filigree and Tuscany Filigree
are designed to be "inside-fit" trim kits. All of these trim kits fit
within the inner perimeter of the Fireplace's Faceplate and re-
main flush within the Faceplate's front surface, see Figure at
right-side. This fitting method allows flexibility in covering the
black visible surface of the Faceplate with non-combustible ma-
terials, only, such as Tile, Marble, Slate, Stone and Brick; as long
as enough room is allowed for the removal of these Mendota
Designer Fronts and the glass door for servicing.
WARNING: COMBUSTIBLE MATERIALS
MUST NOT COVER THE FRONT SURFACE OF
THE FIREPLACE'S FACEPLATE.
Information specific to the installation of the WELLINGTON FIRESCREEN FRONT:
The Wellington Firescreen Front is designed to be a
"full face" trim. The top and sides of these trim kits
cover the perimeter of the Fireplace's Faceplate.
Therefore, DO NOT COVER THE BLACK
BORDER OF THE FIREPLACE FACEPLATE
WHEN INSTALLING THE WELLINGTON
FIRESCREEN TRIM.
Hearth Protection Pad Installation Informa-
tion when planning to Install the Wellington
Front
If planning to install the Wellington Front, the
hearth protection pad installed in front of the DXV-
60 Fireplace must be designed, built and installed
so that the hearth protection pad's top surface is
flush with the bottom-most surface of the DXV60
Fireplace.
21