Driver's Seat Adjustment; Hydraulic Suspension, Pto, And Electrical System Operation - Nortrac 35XT Owner's Manual

Operation Description

2.13 Driver's Seat Adjustment

The driver seat for series XT tractors can be adjusted in
forward and backward direction. To adjust the seat, turn
the adjustment handle (A) on the outside lower left of
the driver's seat (see diagram). At the same time, move
the seat forward or backward. Release the handle once
Figure 2-21 Driver's Seat Adjustment
the required position is reached.
：For safety, the seat should not be adjusted while the tractor is in motion.
WARNING

2.14 Hydraulic Suspension, PTO, and Electrical System Operation

The Series 35XT tractor uses a semi-separate hydraulic lifting system with two types of adjustment modes: position
adjustment and height adjustment. The control handle of the control distributor valve is used to raise and lower farm
implements. Push the handle forward to lower an implement; and pull it back to raise an implement. See "Hydraulic
Lifting System Adjustment" for the adjusting to reach the maximum raising position and for reaching the minimum
lowering position.
2.14.1 Implement Position/Height Adjustment
When the tractor is pulling a cultivator or a plow, a 3-point lift is used to adjust the tilling depth. The tilling depth is
determined by the position of the lowering stop in the reset push rod, which adjusts the height from the ground level
to the plow bottom. When adjusting the stop on the 3-point lift, set the stop to the lower limit, and put the 3-point lift
control handle in the low position. When the farm implement is lowered to the required depth (the adjustment
method is shown in the Adjustment on the Hydraulic Lift System section), it will operate at the tilling depth.
NOTE:
Adjust tilling depth (draft) control according to implement specifications
29