Engine Oil Maintenance And Changing The Oil - Nortrac 35XT Owner's Manual

4.11 Engine Oil Maintenance and Changing the Oil

（1）Raise the tractor hood and remove the oil dipstick
(A) in top right of the engine, and check whether the oil
level is between the upper scale mark and the lower scale
mark. If the oil level does not reach the lower scale
mark, oil should be added until the oil level reaches the
recommended level.
（2）Before maintenance and replacement of the oil ,
preheat the engine. After the oil temperature reaches
50–60°C (122-140°F), remove the oil drain plug (A)
under the oil pan, drain out the dirty oil, replace the
plug, and add new oil. Clean the outside of the oil pan
afterwards.
NOTE:
Filter locations are described from the point of view of an operator sitting in the driver's seat.
IMPORTANT ISSUES:
damage the engine. Replace the engine oil strictly in accordance with the time limits recommended in the
Operation Instruction of the Diesel Engine manual.
Maintenance Instructions
Never mix new and old engine oil or blend different brands of oil, as this can
65
Figure 4-12 Check the Engine Oil Level
Figure 4-13 Engine Oil Drain Plug