Nortrac 35XT Owner's Manual page 38

IMPORTANT ISSUES:
1. When a quick disconnect is not used, the connector seat should be covered with a seal cover to avoid dust.
2.
After the hydraulic output device is used, the operating handle should be set to the neutral position, otherwise,
the hydraulic system may overheat.
2.14.7 Adjustment of the Hydraulic Lift System
When plowing, in order to keep the tilling depth of all the
plowshares (blades) consistent from beginning to end, the
longitudinal and horizontal level adjustments need to be
used.
•
Longitudinal level adjustment: Adjust the length of
the upper tie rod (A) to keep the plow frame level in
the longitudinal direction, so as to make the tilling
depth of all the plowshares the same. When the front
plowshare is deep and the rear plowshare is shallow
or the heel leaves the trench bottom, the upper tie rod
should be lengthened. When the front plowshare is
shallow and the rear plowshare is deep or the heel
compacts the trench bottom, the upper tie rod should
be shortened.
•
Horizontal level adjustment: Adjust the length of the
left and right lifting rods to keep the plow stock level
in the horizontal direction. If the right lifting rod (B)
is lengthened, the tilling depth of the first plowshare
will be deeper. If the right lifting rod is shortened, the
tilling depth of the first plowshare will be shallower.
In general, the left lifting rod (C) should not be
adjusted. The left lifting rod is adjusted only when
the adjustment of the right lifting rod is not enough,
so as to make the tilling depth of all plowshares the
same.
Operation Description
Figure 2-26 Suspension Mechanism
32