Driver's Seat Adjustment; Hydraulic Suspension Operation - Nortrac XT20 Owner's Manual

NOTE: Remove the counterweights from the wheel before removing the rear wheel from the tractor to
avoid injury or damage.

2.13 Driver's Seat Adjustment

The driver seat for series XT tractors can be adjusted
in both a front and rear direction. During the course
of adjusting, turn the adjustment handle (A) on the
outside lower left of the driver's seat (see diagram).
At the same time, move the seat forward or
backward. Release the handle once the required
position is achieved.
Note：
For safety, the seat cannot be adjusted while the tractor is in motion.

2.14 Hydraulic Suspension Operation

The Series XT tractor uses a semi-separate hydraulic lifting system with two types of adjustment modes:
position adjustment and height adjustment. Farm machinery is lifted and lowered through the distributor control
handle. When the handle is pressed forward, the farm machinery will lower; when the handle is pulled back, the
farm machinery will lift. For the highest lifting position and the lowest position of farm machinery, see "hydraulic
lifting system adjustment"
2.14.1 Position Adjustment
When the tractor doesn't have a land wheel, the position adjustment is used. The tilling depth of farm
machinery is determined by the position of the lowering stopper in the reset push rod. When using, the lower
stopper should be adjusted to the preset position. When the farm machinery lowers to a suitable depth, touch the
lower stopper and the shift end of the handle will be pushed back to the neutral position. The farm machinery
will stop lowering and work at the set depth (the adjustment method is shown in the adjustment on the
hydraulic lift system).
2.14.2 Height Adjustment
When the tractor has a land wheel, height adjustment is used. The tilling depth of farm machinery is
controlled by adjusting the height from the ground level to the plow bottom When using, the lower stopper
should be adjusted to the lower limit, and the handle set on the lower position. When the farm machine is
lowered to the required depth (adjustment method is shown in the adjustment on the hydraulic lift system), the
farm machinery will operate at the tilling depth.
NOTE: Adjust draft control according to implement specifications.
Operation Description
Figure 2-23 Driver's Seat Adjustment
26