Setting Global Suffix(Es) - Intermec SR60 Programmer's Reference Manual

Chapter 3 — Configuring Label Transmit Settings
Setting Global Prefix(es)
SET -------------------------------------------
Set Prefix
Use the ASCII chart on page 158 to identify the ASCII character(s) and the
corresponding hex code(s) for the prefix. Then use the bar codes on page 154
to scan the four digits corresponding to the hex values.
END ------------------------------------------

Setting Global Suffix(es)

50
You have added a two-character prefix to all bar code data,
regardless of label symbology. The prefix will be added to the
label data before it is sent to the host.
---------
You may add one or two suffix characters to the standard label
format. To add more than two suffix characters, contact Intermec
Product Support for Full Label Edit (FLE) options.
To set global suffixes
1 Identify your specific system requirements.
2 Using the ASCII chart on page 158, identify the ASCII
character(s) and the corresponding hex code(s) for the ASCII
characters you plan to use as suffixes.
For example, suppose you want to send the two suffix
characters LF (Line Feed) and CR (Carriage Return). The
ASCII chart shows that LF equals 0A hex and CR equals 0D
hex.
SR60 Scanner Programmer's Reference Manual