Read Verification - Intermec SR60 Programmer's Reference Manual

Chapter 4 — Enabling and Configuring Symbologies
Enable 5-Digit
Enable Euro 4-Digit
Enable Euro 5-Digit
END ------------------------------------------
110
---------
---------
---------

Read Verification

You can set the number of minimum reads required to verify
UPC/EAN symbologies.
To set the number of minimum reads
1 Scan the SET bar code.
2 Scan a bar code to select which symbology to verify.
3 Scan the bar code on page 111 that represents the number of
times you wish a bar codes label of that symbology type to be
read before transmission to the host from the list.
4 Repeat Steps 2 and 3 until read verification has been modified
for each symbology you enabled.
5 Scan the END bar code.
SR60 Scanner Programmer's Reference Manual