Factory Default Configuration - Intermec SR60 Programmer's Reference Manual

Appendix A — Factory Default Configuration

Factory Default Configuration

146
The following tables list most of the default configuration values
for the SR60 scanner. The tables also serve as a worksheet where
you can record the changes you make.
For help restoring your scanner to these values, see "Restoring
Factory Default Settings" on page 10.
Wand Emulation Interface Defaults
Feature
Polarity
Signal Speed
Data Format
Idle State
Pre-Noise
Post-Noise
Transmit C128 Function
Characters
RS-232 Interface Defaults
Feature
Baud Rate
Data Bit
Parity Bit
Stop Bit(s)
Hardware Handshaking
Software Handshaking
ACK/NAK Options
Intercharacter Delay
SR60 Scanner Programmer's Reference Manual
Default Your Setting
Space low/Bar
high
High
Normal
Low
None
7
Disable
Default Your Setting
9600
8
No Parity
1
Disable
Disable
Disable
0