Fixed Length Format - Intermec SR60 Programmer's Reference Manual

Chapter 4 — Enabling and Configuring Symbologies
Variable Length Format
SET ------------------------------------------
Enable Variable Length
Format
Set Minimum Label
Length
END ------------------------------------------
86
4 Scan the Set Minimum Label Length bar code.
5 Using the Digits bar codes on page 88, scan the digits to set
the minimum label length you identified in Step 1.
Note: To set a label length less than ten, you must scan a zero
digit first and then the length digit (such as 04, 06, or 08).
6 Scan the END bar code.
---------
---------

Fixed Length Format

All interfaces that are shipped with the standard factory
configuration are set to read variable length labels. If you switch
from the variable to fixed length format, the default label lengths
are 14 characters and 8 digits. All fixed length settings must be an
even number.
To set Interleaved 2 of 5 Fixed Length Format
1 Identify the fixed length settings you want to make.
SR60 Scanner Programmer's Reference Manual