Table of Contents
Advertisement
®
Intel NetStructure
MPCBL0001 High Performance Single Board Computer
Contents
3.14
LED Status
3.14.1
Health LED
The MPCBL0001 SBC supports one bicolor health LED to indicate the SBC's health status, i.e.,
whether a fault or error condition has been detected on the SBC. This LED is mounted on the front
faceplate and driven by the onboard IPMC. The health LED will only be driven to an error
condition (red) if there is a critical or non-recoverable (major or critical in AdvancedTCA
parlance) condition active on the SBC. Alarms could include exceeding sensor thresholds for
temperature and on-board logic voltages. The health LED remains red until the sensors return to a
normal operating value. Hard-drive failures, boot failures, etc. are not considered critical/major
IPMI states, so the IPMC does not explicitly set the health LED in these cases.
Note: The LED's error state color defaults to red, but the color can be overridden. using PICMG 3.0-
defined commands. Refer to
LEDs" on page
Table 26.
Health LED
LED Status (right)
Solid Green
Solid Amber/Red
The default color and override capabilities of the LED follow the LED management requirements
defined in
3.14.2
OOS (Out Of Service) LED
The MPCBL0001 SBC supports one bicolor "OOS" LED, mounted on the front faceplate. The
LED can be driven to display a red or amber color. When this LED is lit, it indicates that the board
is not in service. Its back-end (payload) power could be OFF or ON. Often the OOS state is entered
when a critical fault occurs on the board. In this state, the back-end (payload) power is turned OFF.
A board could be in this state when its back-end power is OFF but healthy, or when a board is fully
powered but not yet deployed, or during the reset process.
Note: Do not extract a board unless the Hot Swap LED is lit.
Table 27.
OOS LED (DS9)
LED Status (left)
Off
Solid Amber/Red
The default color and override capabilities of the LED follow the LED management requirements
defined in
3.14.3
Hot-Swap LED
See
Section 3.9, "Hot-Swap Process" on page
66
Section 3.14.9, "Setting the Default Color for the OOS and Health
69.
Healthy
Fault or error condition
Section 3.14.9, "Setting the Default Color for the OOS and Health LEDs" on page
In service
Fault or error condition
Section 3.14.9, "Setting the Default Color for the OOS and Health LEDs" on page
Meaning
Meaning
53.
Technical Product Specification
69.
69.
Order #273817
Advertisement
Table of Contents
