Channel Step Setting; Scan Type; Beep Sound - Alinco DR-135T MkII Instruction Manual

6. Parameters Setting Mode

Channel Step setting:

This is to select the channel step to be used in the VFO mode.
Refer to the chart below for the relation of the actual step
frequency and how it is displayed.

Scan Type

This is to select the scan resume condition. TIMER setting
allows the radio to resume scanning after 5 seconds, regard-
less of the signal receiving status. BUSY setting resumes scan-
ning when the received signal is gone. The scan mode is ex-
plained later.

Beep Sound

BEEP-ON setting enables a beep that sounds after certain keys
are touched and/or setting is done. BEEP-OF shows that the
beep function is off.
22