Dcs Scan; Key-Lock Function; Tone Burst - Alinco DR-135T MkII Instruction Manual

7. Advanced Operations

•DCS scan

Same as previous, but for DCS code search.
1.
Press TS/DCS key to enter DCS setting mode.
2.
Press UP/DOWN key for more than 1 second
but less than 2 seconds to start. It searches the
104 DCS codes in order.
3.
The 1 MHz order decimal point will flash.
4.
The scan stops when the matching code is de-
tected.
5.
The scan won't resume until the operation is
repeated.
6.
Press any key (other than UP/DOWN keys) to
exit.

KEY-LOCK FUNCTION

This will lock the keys to avoid unintentional changes.
1.
Press FUNC key and press TS/DCS key while
F icon is on the display.
2.
The [
3.
With this function activated, only the follow-
ing commands can be accessed:
• PTT
• FUNC+TS/DCS to cancel this function
• Monitor function (to release squelch for weak
• Squelch setting
• UP/DOWN keys

TONE BURST

Press the DOWN key while PTT is pressed. The tone burst will be transmitted as long as both keys
are pressed together. Usually just a few seconds of burst is enough to activate the repeater.
28
] icon appears.
signal reception)