Alinco DR-135T MkII Instruction Manual page 37

3.
Place the cushion sticker on the VCO shield case (a metal housing on the circuit
board).
* To place it on the DR235/435, remove the cushion from the EJ-41U unit and place
the cushion that is provided.
Packet Mode Setting
1.
Press FUNC key. While F icon is on, press SQL key. [
display and the transceiver enters packet mode. Repeat the same sequence to exit
from packet mode.
2.
Use the computer keyboard to send designated commands from your PC to enter the
packet network and start operation. Refer to the chart for TNC commands. Use the
commands to select between 1200/9600 bps data speed.
Reference:
The configuration of EJ-41U is as follows. Please use PC commands to program.
• Data Speed (Transfer Rate)
• Data Length
• Parity Bit
• Stop bit
• Flow Control
Once the EJ-41U is programmed, the settings are stored in memory even if the unit
is removed from the transceiver. Some EJ-41U functions may be limited as com-
pared to those found in an external TNC.
W1
W2
CN107
VCO case
9600bps (to computer)
8 bit
none
1 bit
Xon/Xoff
8. PACKET OPERATION
DSUB-9
Bottom side
] appears on the LCD
35