Channel Step Setting; Scan Type; Beep Sound - Alinco DR-635T Instruction Manual

Parameter Setting Mode

Channel Step setting

This is to select the channel step to be used in the VFO mode.
Refer to the chart below for the sequence of the actual steps
and how they are displayed.
STEP 5
(5 kHz)
STEP 100
(100 kHz)
NOTE: The default is as follows.
• DR-635E [STEP 12.5]
• DR-635T [STEP 5]

Scan Type

This is to select the scan resume condition. The TIMER set-
ting allows the radio to resume scanning after 5 seconds, re-
gardless of the signal receiving status. The BUSY setting re-
sumes scanning when the received signal is gone. The scan
mode is explained later.

Beep Sound

This is to change the volume of a beep sound during operation.
1.
The [BEEP2] icon appears on the display.
2.
By rotating the dial, the display will change as
below and the volume of the beep sound will
be changed.
Volume low
BEEP 1
28
STEP 8.33 STEP 10
(8.33 kHz) (10 kHz)
STEP 50 STEP 30
(50 kHz) (30 kHz)
Volume High
BEEP 2 BEEP 3
(Refer page 27 for how to enter the setting mode.)
STEP 12.5 STEP 15
(12.5 kHz) (15 kHz)
STEP 25 STEP 20
(25 kHz) (20 kHz)
BUSY
Volume 0
BEEP OFF
TIMER