Theft Alarm - Alinco DR-135T MkII Instruction Manual

THEFT ALARM

This alert uses a beep sound when the unit is about to be removed in an improper manner. This
function is useful when the unit is installed in a vehicle.
NOTE: Remove wire from steering wheel before attempting to drive vehicle.
[Operation 1]
Setting: Connect the DC cable direct to the battery.
1.
Connect the provided alarm cable to the DATA jack on the front panel as shown.
Secure the other end of the cable to an object that stays fixed in the vehicle.
2.
Enter the Parameter Setting mode by pressing FUNC key for more than 2 seconds.
Use SQL or UP/DOWN keys to select menu and rotate the dial to set SCR-ON.
Press any key other than SQL/UP/DOWN key to enter the setting and exit.
3.
Turn off the unit with main power switch. The TX LED will be lit.
To turn off the alarm function, turn on the unit, enter the Parameter setting mode again, and select
SCR-OF. When alarm is activated, the decimal points on 100 MHz and 10 kHz order will flash on
display.
Function:
1.
When the alarm cable is removed from the DATA jack or cut without using the
proper sequence, the alarm sounds for 10 minutes. During the alarm, the unit goes to
receive on memory channel 99, according to its pre-programmed setting (TSQ/DCS
accepted).
2.
When a signal is received on ch.99 the alarm stops.
3.
Turning on the unit with SQL key pressed also cancels the alarm.
4.
Turn the unit off again with the alarm cable connected properly. It returns to the
alarm mode.
Alarm cable A
Handle of the car etc.
NOTE: 1. The alarm functions only when the unit is turned off.
2. When the alarm is activated (SCR-ON or DLY), the Ignition key function does not work.
DC power cable
Transceiver
Alarm cable B
7. Advanced Operations
Battery
31