Alinco DR-135T MkII Instruction Manual page 48

Appendix
Command form
Name Short
FIRMRNR FIR
FLOW F
FRACK FR
GBAUD GB
GPSSEND GPSS
GPSTEXT GPST
HBAUD HB
LOCATION LOC
LPATH LPA
LTEXT LT
LTMON LTM
MCOM MCOM
MCON MC
MONITOR M
MRPT MR
MYCALL MY
PACLEN P
PACTIME PACT
PERSIST PE
PPERSIST PP
46
Default Parameters
OFF ON/OFF
ON ON/OFF
3 0 - 250
4800 4800/9600
- 0 - 159
characters
$PNTS 0 - 6
characters
1200 1200/9600
EVERY 0 EVERY/
AFTER n
( n = 0 - 250 )
GPS Call1 ( VIA
call2, call3, ...
call9 )
- 0 - 159
characters
0 0 - 250
OFF ON/OFF
OFF ON/OFF
ON ON/OFF
ON ON/OFF
NOCALL 6 characters
+SSID
128 0 - 255
AFTER 10 EVERY/
AFTER n
( n = 0 - 250 )
128 128
ON ON
Description
The other station sends a notice (packet) to you if it is not
ready to receive data. When ON, receiving such a notice
causes the TNC to suspend transmission until it receives a
"ready" notice.
When ON, starting key entry causes the computer to stop
displaying received packets.
Specifies the interval from one transmission until retry
of transmission. The unit of the parameter is 1 second.
Selects 4800 or 9600 bps as the transfer rate between
the TNC and the GPS receiver.
Specifies the content of the data to be output to the GPS
receiver; this data is used to pro gram the default settings on
the receiver. The output data is not stored in memory.
Specifies the type of a message to be determined by
LTEXT.
Selects 1200 or 9600 bps as the transfer rate between
packet stations.
If set to EVERY, sends GPS data at intervals of the speci-
fied period (n). If set to AFTER, sends GPS data only once
after the specified period (n). The unit of n is 10 seconds.
Specifies calls signs to send GPS data. Call 1 is the call sign
of the destination. Call2 to call9 are call signs of stations to
be digipeated through.
Specifies the content of a message to be included in GPS
data.
Specifies the interval for displaying a message determined
by LTEXT on the screen; a message appears like a received
beacon packet. The unit of the parameter is 1 second.
When ON, causes the TNC to also monitor control packets.
When OFF, causes it to monitor only information packets.
When ON, causes the TNC to monitor other stations
while in connection with the target station.
When ON, causes the TNC to monitor packets.
When ON, causes the TNC to display the entire digipeat
list for monitored packets.
Specifies your call sign.
Specifies the maximum length of the data portion of a
packet.
If set to EVERY, sends a packet at intervals of the specified
period (n). If set to AFTER, sends a packet only once after
the specified period of (n). The unit of n is 100 milliseconds.
Specifies a parameter to calculate probability for the
PERSIST/SLOTTIME method.
Causes the TNC to use the PERSIST/SLOTTIME method
when ON, or the DWAIT method when OFF.