Belt And Belt Cover; Jetfence; Assembly; Adjustments - Jet JWTS-10JF Operating Instructions And Parts Manual

Belt and Belt Cover

1. Lower the saw blade completely. This makes it
easier to position the v-belt on the arbor pulley.
2. Position the v-belt (A, Fig. 24) on the arbor
pulley, lift up on the motor assembly, place the
v-belt on the motor pulley (B, Fig. 24), and
carefully lower the motor.
3. Place the M8x40 carriage bolt (C, Fig. 24)
through the hole in the belt guard bracket.
Place spacer (D, Fig. 24) onto the carriage bolt.
4. Fasten the belt cover (B. Fig. 25) to the belt
guard bracket with an M8 flat washer and M8
wing nut (B, Fig. 25).

JETFENCE

Assembly

1. Place fence body (A, Fig. 26) into the fence
(B, Fig. 26).
2. Install four bolts (C, Fig. 26) with flat washers
and lock washers. Hand tighten.
3. Place the fence assembly on the guide rails,
slide to the nearest miter slot and clamp the
handle (D, Fig. 26) to lock.
4. Grasp the fence toward the rear of the saw and
move left or right until the fence lines up with
the miter slot.
5. Tighten the four bolts (C, Fig. 26).
6. Attach the cursor to the fence body with one
3/16"x1/4" pan head screw.
7. Lock the fence and take a test cut. Measure
the test cut and compare to the cursor reading.
Adjust the cursor, if necessary.

Adjustments

The JETFENCE has an adjustable rear slide (index
# 15 in the parts breakdown). The rear slide has
been adjusted at the factory and should not need
further adjustment. If, however, you find the space
between the fence and the table is not even front to
back (approximately 1/16"), make the following
adjustment:
1. Remove fence plug (Parts List Item #14).
2. Loosen two nuts (Parts List Item #32).
3. Adjust rear slide up or down.
4. Tighten two nuts (32) to lock rear slide in place.
The rear slide is properly adjusted when the space
between the fence and the table is approximately
1/16" and is same along the entire length of the
fence.
19
Figure 24
Figure 25
Figure 26